Kathrein Tools Editor

**sansar** · 05.03.11, 12:51

Mini-uboot Instalator 0,86.

Basic differences:
- Miniuboot does not require any special firmware for operation. Because of its ¹ Size upload to a place of dot ¹ d ¿unused used by the system.
- Miniuboot image allows you to update via USB. Doœæ valuable, as it is uploaded to the flash E2, or Neutrino when ¿in both cases are solved on a standard partition of emergency serv ¹ ca supports firmware update with USB.
- Miniuboot NOT allow you to run the firmware via NFS, with only a flash and USB
- Ka ¿dy soft ¹ must have a separate partition (like uboocie choice of firmware)
- Implemented functions and fatload speedboot przyœpieszaj head will start the process of firmware with a pen-

Required programs:
- AAF multipart Installer v1.9
- CreateMini V1.4, if we want a more advanced zrobiæ ³ ¹ configuration (see section 5)

1st Installation miniuboot:
- Running MPI 1.9
- Configure the IP address if needed
- Press the button "Connect"
- After a while you press the button "Mini U-Boot"
- Press the button "Install Mini U-Boot"
- After installation should uaktualniæ przcisk yourself to "Deactivate"

2nd Recording Neutrino Flash using MPI 1.9 ¹:
- Running MPI 1.9
- Configure the IP address if needed
- Press the button "Connect"
- Press the button "Flash Tool"
- In the "Select Full Image" choose the downloaded flash Neutrino.
- Press "Flash full" and waiting quietly at the end of the operation

3rd Recording to flash the firmware via USB:
- Check if you have the appropriate firmware ¹ ¹ in flash command cat / proc / mtd "
If you returned a dock ³ exactly the same as below, you can dalesz
Running a Started

[HIDE][/HIDE]

Konu Bilgileri
	Konu Başlığı Kathrein Tools Editor	Konudaki Cevap Sayısı 0
	Şuan Bu Konuyu Görüntüleyenler	Görüntülenme Sayısı 1013

Konuyu Toplam 1 Üye okuyor. (0 Kayıtlı üye ve 1 Misafir)